• Skip to primary navigation
  • Skip to main content
  • Skip to primary sidebar
  • Skip to footer

KB6NU's Ham Radio Blog

KB6NU's Ham Radio Blog
  • HOME
  • Study Guides
  • Teach a One-Day Tech Class
  • W8SRC Repeater Guide
  • Advertise
  • Hire Me

Amazon Recommends Ham Gear

August 8, 2016 By Dan KB6NU 3 Comments

I am an Amazon affiliate and list amateur radio products here on KB6NU.Com. When you purchase one of those products, I get what Amazon calls an “advertising fee.” I don’t make much money this way, but everything helps, as they say.

This morning, Amazon sent me a list of products that they recommend I display on my website. Some of them were clearly not amateur radio products, but a lot of them were. Here are the best of those.

NOTE: Unless otherwise noted in the product description, I am not personally endorsing the product.


100′ RG8X Coax with molded and solder PL-259 connectors

100 ft. RG-8X coax great for Ham Radio and CB. These are double-shielded 50 ohm coax with molded-on and soldered strain relief PL-259 connectors on each end. Specifications: PL-259 connectors on both ends of coaxial cable 50Ω Low-loss RG-8x Fully molded Nickel-plated connectors.

Baofeng black UV-5R V2+ Plus (USA Warranty)

  • Frequency Range: 136-174 / 400-479.995 MHz. Metallic upgraded, durable housing. English user manual included.
  • Upgraded 2014 Bright & easy to read two-color LED display.
  • Compatible with UV-5R 3800mah and 3600mah extended batteries. More enhanced construction and features than previous UV-5R and UV-5RA.

Browning BR-180 dual-band mobile antenna

This is interesting. I’ve never heard of Browning before….Dan

  • 37-Inch tall
  • 144-148 MHz/430-450 MHz
  • 3 dBd gain VHF/6 dBD gain UHF
  • NMO mounting (mount sold separately)
  • Center load, Maximum Power 100 Watts

uxcell S0-239 UHF double female coax adapter connector plug (2 pcs)

  • Product Name : UHF Double Female Adapter;Color : Silver Tone
  • Material : Metal
  • Size : 27 x 15mm/1.1″ x 0.6“ (L*D)
  • Weight : 34g
  • Package : 2 x UHF Double Female Adapter

DHT Electronics Handheld Antenna Cable for Wouxun Baofeng Quasheng Linton – Adapter for UHF Base and Mobile Antennas – SMA Female to UHF SO-239 Female Connectors 6″

  • Package include:1 x cable
  • Cable length: 6 inches
  • Impedance :50 ohm

Authentic Genuine Nagoya UT-72 Super Loading Coil 19-Inch Magnetic Mount VHF/UHF (144/430Mhz) Antenna PL-259

  • Complete with Antenna, Magnet, SMA adapter & heavy duty Cable
    PL-259 with included SMA Female adapter, Dual-Band VHF & UHF (137-174, 400-520 Mhz), Weatherproof, Strong Rare Earth Magnet Base
  • Super Loading Coil: By introducing a very tightly wrapped loading coil, it increases UHF reception and range
  • Easy To Install, Omni-Directional, Requires Metal Ground Plane, Measures 19 inches, Stainless Steel Antenna
  • To avoid counterfeit Nagoya models – insure your listing shows “sold by BaoFeng Tech”

Baofeng USB Programming Cable for Baofeng Two way Radio UV-5R, BF-888S,BF-F8+ With Driver CD

At only $3, I’m not sure whether this is the genuine cable or not….Dan

  • Allows to hookup to PC for Radio Programming
  • Easy to use, Compatible with most radios with 2-pin Mic Connector
  • Affordable Price

Authentic Genuine Nagoya NA-771 15.6-Inch Whip VHF/UHF (144/430Mhz) Antenna SMA-Female for AnyTone, BaoFeng, and Yaesu

  • Certified Original Nagoya Antenna – with an exclusive manufacturing partnership with BaoFeng Tech
  • Updated Model – May Require a Rubber spacer (included) and has an extended antenna cover to protect your radio SMA male base from the elements
  • Counterfeit Warning: A silver package label (Marked EVO) means the antennas shipped from China – Authentic Nagoya Antennas do not have a Silver Label (and are produced in Taiwan)
  • Compatible with the ANILE-8R, NSTIG-8R, OBLTR-8R, and TERMN-8R
  • Compatible with all AnyTone, BaoFeng, some Wouxun, and some Kenwood Handhelds

In addition to these products, there were three code courses, including one from the ARRL, one from Gordon West, and a really oddball one that purports to teach children Morse Code by—you guessed it—associating characters with visual cues. Uggggh.

Related posts:

  1. 2014 Tech study guide: types of feedline, connectors
  2. Don’t throw out that cable!
  3. Recommendations from Amazon
  4. Would you buy a Chinese mobile radio on Amazon?

Filed Under: Everything Else

Reader Interactions

Comments

  1. Brick says

    August 9, 2016 at 8:13 am

    Hey – that’s my trick!

    http://www.brickolore.com/2016/08/there-are-ham-things-you-are-looking-for.html

    Hope you have better luck with yours!

    Reply
    • Dan KB6NU says

      August 9, 2016 at 9:01 am

      You have some items listed that I don’t! I’m going to have to put those on my website, too. :)

      I do OK. It’s worth the time it takes me to post these items. I think it comes down to website traffic. I get quite a few page views per week here on KB6NU.Com.

      Reply
  2. Dave New, N8SBE says

    August 9, 2016 at 11:45 am

    I inspect any HT adapter cable assembly before purchasing, after getting burned by Tower Electronics (they show up at Dayton and several of the local Michigan/Ohio hamfests). Their SMA adapter cable was smashed crimped by what looked like a pair of pliers on the SMA end, making it fail almost immediately. I saved it for the next hamfest, and brought it back, where they accused me of not installing the cable properly on the HT, and refused to replace it. I looked at the remainder of their stock, and found they were all defectively crimped, and pointed it out to them. They said, “We have them done for us, and they are a professional house. We have no control over how they do them.”

    I then went to Webster Radio (another vendor that does Dayton and several of the local Michigan/Ohio swaps) and found a properly-crimped (hex crimp with the proper tool) SMA adapter cable. I bought two just to have a spare, but I’ve never had to use the spare.

    So, be sure you inspect the crimp on the SMA connector, and refuse/return any cables that are not done properly. Also make sure that when you put the adapter on your HT, that you turn the HT, not the cable, to avoid putting any stress on the SMA connector/cable interface.

    Reply

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *

Primary Sidebar

No Nonsense Technician Class License Study Guide (for tests given between July 2026 and June 2030)

New No Nonsense Technican Class Study Guide now available!

The 2026 version of my Tech Class study guide is now available, and as always, the PDF version is FREE!. The ePub version costs $11.97, and a Kindle version and paperback version will be available on Amazon shortly.

Click here to get all of my "No Nonsense" study guides.

Also available: The CW Geek's Guide to Having Fun with Morse Code

W5SWL.Com
Retevis Ailunce H1 DMR Radio
DXpander: Cobweb antennas, Laser Cutting

You’ve got mail!

Enter your email address below and get an email every time I publish a new post.

Email


I frequently teach classes to help newcomers get their licenses. The next class will take place on Saturday, October 10, 2026 on the University of Michigan campus. Click here for more information.

If you can't make the class, subscribe to the mailing list to be notified of when the next class will be held.

You can always download my free study guide, and if you have any questions about the classes, or amateur radio in general, please feel free to email me directly.

Support KB6NU.Com

Donate $7.30 and get two of these cool stickers. Measuring 4.25-in. W by 2.75-in. H, it's perfect for your car, your shack, or wherever!

Contact me

If you have a question or comment about one of my blog posts, or a question about any of the material in my study guides, or just a question about ham radio in general, you can email me at [email protected].

Blogs You Should Also Read

  • AE5X: A CW-centric blog from Kingswood, Texas
  • K0LWC Blog
  • LA3ZA Ham Radio Blog
  • Little Radios, Big Fun – WB3GCK
  • Mr. Vacuum Tube's Blog
  • Radio Artisan – K3NG
  • The K0NR Weblog
  • VE3WDM's QRP Ham Radio Blog
  • W2LJ’s Blog

Ham Radio Websites

  • Dashtoons – The Hammin' Comedy by Jeff K1NSS

Podcasts

  • ICQ Podcast
  • Linux in the Ham Schack
  • No Nonsense Amateur Radio Podcast
  • Resonant Frequency Amateur Radio Podcast

Recent Comments

  • Mir Labs on Ten Steps to Mastering Morse Code
  • Skip K4EAK on Is the ARRL finally feeling the heat?
  • Victor on 468: Ham Radio’s Magic Number
  • Goody K3NG on Not1MM now working on my Linux box!
  • Mir Labs on JA1NUT: Two Issues in Morse Code Learning

Meta

  • Log in
  • Entries feed
  • Comments feed
  • WordPress.org

Footer

Copyright © 2026 Daniel M. Romanchik, KB6NU · Log in